The Octopus V2 RDA rebuildable Atomizer has dual coils attached to 8 wicks on each coil allowing for the twice amount of e-liquid that the first version. to be added to it at one time.
The wicks do an excellent job providing e-liquid to the coil and like most atomizers, the RDA Drip atomizer has a clean bold tasting hit. The RDA has tiny holes drilled into the side of it which provides greater airflow. The increased airflow helps generates a bigger hit with tons of vapor.
The atomizer comes installed with 2 x 1.7 Ohm replaceable coils that are easily swapped via 3 posts with thumb screws. The opening on the top is sized for a 510 drip tip so you can use your favorite drip tip.
The RDA is compatible with every 510 threading.
SmoktechOctopus RDA (Rebuildable Dripping Atomizer) is for **Advanced users only!
Specifications :
- Sealed battery connector
- Air hole located on outer casing
- 510 Threaded
- Screw-less positive/negative post
- Rebuild using fiberglass or silica rope and wire
- Oxidized Aluminum construction
- Fits most 510 drip tips
- Come with 1 Pre-installed wick and wire
- Length: 35mm
- Diameter: 14mm
To rebuild The Octopus V2 RDA please follow these instructions:
- Remove the cap
- Release both screws which fix the wire
- Bend an 8cm string of 1mm Silica wick at least 3 times.
- Do at least three coiled of the 0.16mm NiCr-wire (five with the 0.20) around the Silica
- Put the wire ends through the little holes and tighten up the screws to fix the wick.
- Drip some liquid on the wick and Enjoy!!!